Applications: 1) All TITAN MOTOR CONTROLLERS (ESC) 2) Emeter v1 and Emeter v2* 3) EOS 06xxi CHARGERS to PC Port for: *EOS0610i NET and DUO - Firmware upgrades and PC Software *EOS0606i DC and AC/DC - PC Software (to be confirmed) USING the TI-PRGUSB ADAPTER : TITAN ESC * Whenever connecting the PRGUSB Adapter, be sure that GRD/V+/Tx/Rx orientation is correct. * For TITAN ESC, note that the "blanked" pin on the adapter connector is always next to GRD *The Adapter supplies power to the TITAN ESC, so a battery pack must NOT be connected to the TITAN ESC during programming. EMETER v1 *HP-TI-PRGUSB cannot be connected directly to EMETER. You must first insert the adapter for Emeter, which is included with every USB TI-PRGUSB. (pictured above, at bottom right of photo) *For EMETER v1, note that you MUST turn Emeter ON first, then connect TI-PRGUSB to Emeter, when using Emeter PC Data Software. (otherwise, you will see a "low battery" warning from Emeter...) EOS CHARGERS #HP-EOS06-PCCBL *HP-TI-PRGUSB cannot be connected directly to EOS Chargers. A wiring harness/extension is needed between the charger and USB Adapter. Buy harness part #HP-EOS06-PCCBL (pic right $1.95srp). Or see the 0610i Firmware Update Manual (last page) for DIY wiring arrangement.
