This is the Futaba 6EXH 6-channel Helicopter Radio with the
R138DP PCM Receiver and four S3151 Servos.
This radio is diode protected to prevent overcharging, which means the
battery cannot be discharged through the transmitter.
FEATURES: Six model memory, four character model naming
Multiple swash plate styles, data reset, trainer capability, EPA,
exponential and digital trims
Data Input Lever allows easy setting of end points and rates for all
six channels
Five-point adjustment with two curves on both Throttle Curve, Pitch
Curve, Normal and Idle Up
Rate selection on both gyro mixing and revo mixing
Small speaker in face plate emits audio alarms
Throttle Hold switch for performing autorotation maneuvers and
reducing idle for starting
INCLUDES: 6EXH 6-Channel Transmitter with crystal
R138DP PCM Receiver with crystal,
Four S3151 Servos,
NT8F600B 600mAh Transmitter Battery,
NR-4RB 1000mAh Receiver Battery,
FBC-19B (4) Wall charger,
Switch Harness,
Neckstrap, frequency flag set, servo mounting hardware with extra
servo horns
REQUIRES: Charging batteries overnight
SPECS: Transmitter
Modulation: FM (PPM) and PCM 1024
Power Supply: 9.6V NT8S600B NiCd battery or 12V alkaline battery
Current Drain: 250mA
R138DP PCM Receiver
Narrow Band: 20kHz
Intermediate Frequency- 1st IF: 10.7MHz
2nd IF: 455kHz
Power Requirements: 4.8 to 6.0V (shared with servos)
Current Drain: 13mA
Length: 2.50" (63.5mm)
Width: 1.38" (35.0mm)
Height: 0.88" (22.0mm)
Weight: 1.75 oz (50 g)
S3151 Servo
Speed: 0.21 sec/60 degrees at 4.8V
Torque: 43.1 oz-in @ 4.8V
Dimensions: 1.59x0.79x1.42 in (40.6x20x36mm)
Weight: 1.48oz (42g)
